Skip to main content

Water sensor feedback control system for surface irrigation

Humpherys, A.S. and Fisher, H.D. (1995) Water sensor feedback control system for surface irrigation. Applied Engineering in Agriculture. 11(1):61-65.

[img] PDF
856.pdf

Download (484kB)

Abstract

A water sensor feedback control system was developed to control semiautomatic irrigation of basins and
borders. When water reaches a sensor at a downfield irrigation cutoff point, a signal to terminate irrigation is sent via
wire or infrared (IR) telemetry to a station controller or receiver at the upper end of the field. The sensor uses a
monostable interface to strengthen the signal for wire transmission, and prevents continuous IR transmission during the
time the sensor is immersed or remains wet. The water sensor controller, powered by a 12-V battery, uses a silicon
controlled rectifier (SCR) triggered by the feedback signal to discharge a capacitor through an electric solenoid. The
energized solenoid actuates a gate release or valve to terminate irrigation of one field segment and begin irrigation of
another. The water sensor system was tested in a level basin irrigation system.
A sensor costs approximately U.S. $30, while single and dual station controllers cost about $65 to 80. Both can be
portable to minimize the number of units required.

Item Type: Article
NWISRL Publication Number: 0856
Subjects: Irrigation > Irrigation control
Practical farm efficiency
Mass Import - autoclassified (may be erroneous)
Depositing User: Dan Stieneke
Date Deposited: 20 Nov 2010 21:54
Last Modified: 23 Nov 2016 21:24
Item ID: 634
URI: https://eprints.nwisrl.ars.usda.gov/id/eprint/634